3” Round Bench Block Staking Anvil Block Toolmakers Hammer Riveting Hardened

Description

3" Round Bench Block
DESCRIPTION
Block Dia.:
3" (75mm)
Block High : 1-1/2" (
38mm)
Hole Die.:
1/8” To 5/8” (
3-16mm
)
A handy tool for holding work when driving pins, drilling, etc.
The knurled side provides a good gripping surface.
V-groove across the face accommodates round and odd shaped stock.
Hardened and ground.
APPLICATION
The top surface has been ground flat with respect to the bottom. Use it when you need to raise something up while keeping it parallel to the support surface. There is a 90° V cut all the way across the face. Use it to hold round stock. If you clamp the round stock into this V, then you can use your hacksaw to cut it and not worry about it rolling. Just keep that blade away from the block. You can also clamp some square stock into this V and have the opposite edge pointing straight up. That position is hard to achieve without a V. And finally, what is with all of those holes?
The size of these holes has been carefully selected to match common drill and tap sizes.
The only thing of note on the bottom is that it has been ground to be parallel to the top.
Hardened and ground.